氣力輸送設備在生活中已經廣泛使用，但系統安全操作是一個不容忽視的問題，具有環保的氣力輸送將氣力輸送設備系統的安全操作規則分享給大家，下面一起了解下粉煤灰氣力輸送設備系統安全操作規程吧!

Pneumatic conveying equipment has been widely used in daily life, but system safety operation is an issue that cannot be ignored. Environmentally friendly pneumatic conveying will share the safety operation rules of pneumatic conveying equipment system with everyone. Let's learn about the safety operation rules of fly ash pneumatic conveying equipment system together!

1、安裝工作全部完成，所有氣力輸送設備按要求固定牢固，緊固件緊固牢固，密封面嚴密，所有標識清晰，與設計一致。

1. All installation work has been completed, and all pneumatic conveying equipment is securely fixed as required, with fasteners firmly fastened and sealing surfaces tightly sealed. All markings are clear and consistent with the design.

2、清理各電場吸塵器的灰斗、緩沖灰倉、管道及連續泵內可能存在的垃圾、水分，及時復原。

2. Clean up the ash hopper, buffer ash bin, pipeline, and continuous pump of each electric field vacuum cleaner, and restore them in a timely manner.

3、首先要檢查各閥的動作(包括電磁閥)，要求各閥的動作位置、開閉的靈活性。

3. Firstly, it is necessary to check the action of each valve (including solenoid valves), requiring the flexibility of their position and opening/closing.

4、具備要求的控制氣源和灰倉頂吸塵器能夠正常工作。

4. The required control air source and dust bin top vacuum cleaner can work normally.

5、動力送風機、吸塵器送風機等要求可以順利停止。

5. The power supply fan, vacuum cleaner supply fan, etc. are required to stop smoothly.

6、對所有旋轉部件、把手的無障礙、減速箱、齒輪箱等補充所要求的潤滑脂。

6. Add the required lubricating grease to all rotating parts, handles, gearboxes, gearboxes, etc. for accessibility.

7、有其他相關條件。

7. There are other relevant conditions.

啟動注意事項

Precautions for startup

1、灰庫的上部吸塵器工作。 請注意吸塵器的送風機是否正常工作。 布袋的回吹壓力是否正常，各回吹電磁閥是否按規定的順序間隔動作。

1. The upper vacuum cleaner of the ash silo is working. Please pay attention to whether the air supply fan of the vacuum cleaner is working properly. Is the blowback pressure of the bag normal, and are the blowback solenoid valves operating at regular intervals according to the specified sequence.

2、動力鼓風機的工作：注意觀察電機電流值和鼓風機出口壓力值是否正常。 如果壓力迅速上升或電流值上升，則兩個進氣門可能未按要求打開或未按要求打開。 請立即停止檢查，將閥打開到規定位置。

2. Operation of power blower: Pay attention to observing whether the motor current value and blower outlet pressure value are normal. If the pressure rises rapidly or the current value increases, the two intake valves may not open as required or not open as required. Please stop the inspection immediately and open the valve to the designated position.

3、連續泵鎖裝置的工作：注意運行是否穩定，是否有卡住。

3. The operation of the continuous pump locking device: pay attention to whether the operation is stable and whether it is stuck.

4、掉灰的管子，要注意材料是否正常，一般可以用聽音和用手測試溫度的方法進行檢查。

4. For pipes that have fallen dust, attention should be paid to whether the material is normal. Generally, it can be checked by listening to sound and testing the temperature by hand.

氣力輸送設備發生下列情況，應當采取相應的緊急停止措施：

In the event of the following situations occurring in pneumatic conveying equipment, corresponding emergency stop measures should be taken:

1、動力鼓風機的壓力計值、電流值超過額定值而急速上升，且不下降時，可以判斷為管道堵塞，緊急停止連續泵的氣閘運轉，必要時停止動力鼓風機。

1. When the pressure gauge value and current value of the power blower exceed the rated value and rise rapidly without decreasing, it can be judged as pipeline blockage, and the continuous pump's airlock operation should be stopped urgently. If necessary, the power blower should be stopped.

2、巡邏人員發現吸塵器嚴重膨脹或嚴重外泄時，停止連續泵的氣閘器，延遲10~20S停止動力鼓風機。

2. When patrol personnel discover severe expansion or leakage of the vacuum cleaner, stop the air brake of the continuous pump and delay for 10-20 seconds to stop the power blower.

3、如果發現落灰管擋不住灰，一般采用敲擊的方法進行疏通，不需要停止運輸系統的運行。

3. If it is found that the ash pipe cannot block the ash, it is generally cleared by tapping without stopping the operation of the transportation system.

4、連續泵鎖緊器堵塞或堵塞時，應及時停止該設備，并相應停止設備。

4. When the continuous pump lock is blocked or obstructed, the equipment should be stopped in a timely manner and the equipment should be stopped accordingly.